OPERATION 16.2.4 EMERGENCY TRAVEL OPERATION The normal gear shift operation is performed by electric signals. In the event of an electrical system failure and the machine does not move, use the following procedure to move the machine. WARNING When performing this operation, always keep the engine stopped, except when starting the machine. When starting the engine, always depress the brake pedal and check that the surrounding area is safe. This operation enables the machine to be driven under its own power to the nearest repair shop when there is an electrical system failure. This operation must not be used for any other purpose.
Always keep the speed lever at the normal position Install the plate (2) securely, ensuring that the spool does not come out when traveling. Always request that your distributor perform the emergency travel operation, or consult your distributor before performing it yourself. 1. Set the parking brake switch to the ON position and set the speed lever to the neutral position. 2. After loosening the bolt (1), remove the plate (2). 3. Pull out the spool (3) to the F position, or push the spool into the R position. The transmission range for this operation is 2nd. 4. After resetting the spool (3) to the neutral position, install the plate (2) and the bolt (1) to hold it into position. 5.
Depress the brake pedal, start the engine, release the parking brake and let the brake pedal out slowly. WA450-3MC 2-88