BODY (UPPERSTRUCTURE) / Pump Device Disassembly of Main Pump 5. Place front casing (8) on a wooden block (120 mm (4.72 in) square or more) with the rotor (4) side facing upward. 6. Remove retaining ring (1), inner race (12) and needle bearing (13) from drive shaft (11). IMPORTANT: The valve plate (3) side of rotor (4) is a sliding surface. Do not damage the sliding surface. 7. Put a hand on retainer (18) and remove the rotor (4) assembly from drive shaft (11). Place the rotor (4) assembly with the valve plate (3) side facing downward. 8. Put a hand under retainer (18) and remove the retainer (18) assembly from rotor (4). 9. Remove servo pistons (17) (3 used) from pump casing (2). 10.
Remove bushing (16) and springs (15) (7 used) from rotor (4). 11. Remove plate (19) from swash plate (6). CAUTION: Pump device weight: 92 kg (205 lb) 1. Secure the pump device on a workbench with the pilot pump side facing downward. 2. Remove O-ring (38), O-rings (40) (5 used) and spring pins (39) (2 used) from pump casing (2). CAUTION: Front casing (8) weight: 36 kg (79.5 lb) 3. Remove socket bolts (9) (8 used) from front casing (8). : 12 mm IMPORTANT: Do not damage inner race (12) with drive shaft (11) attached. 4. Remove the front casing (8) assembly from pump casing (2).
At this time, drive shaft (11), the rotor (4) assembly and restrictor pin (43) are removed together with front casing (8). NOTE: When removing front casing (8), raise the pump casing (2) side a little in order to prevent rotor (4) from falling off. NOTE: Do not remove restrictor pin (43) unless necessary. Restrictor pin (43) may be left in pump casing (2). W2-6-13