BODY (UPPERSTRUCTURE) / Pump Device Assembly of Main Pump 1. Install the outer race of needle bearing (13) to pump casing (2) with the stamped mark facing outside by using a special tool and a hammer. IMPORTANT: Replace valve plate (3) and rotor (4) as an assembly. IMPORTANT: Install valve plate (3) of the rotor (4) assembly with the oval hole facing downward. 2. Apply grease onto the flat surface of valve plate (3). Install valve plate (3) to pump casing (2) while aligning with knock pin (14). 3. Install servo pistons (17) (3 used) to pump casing (2). IMPORTANT: Check the direction to install feedback link (26). 4.
Install the feedback link (26) assembly to pump casing (2) while aligning with the groove for pin (24). At this time, face link pin (29) to the front casing (8) side. 5. Assemble rotor (4) into an assembly in the following procedures. Place rotor (4) with the center projection part facing upward. Install springs (15) (7 used) to rotor (4). Cover rotor (4) with bushing (16). NOTE: Drive shaft (11) can be easily installed if aligning the spline in bushing (16) with the spline in rotor (4) when covering with bushing (16). Insert plungers (5) (7 used) through the retainer (18) flat surface and install to rotor (4). 6.
Evenly tap and install inner race (12) to drive shaft (11) by using a special tool and a hammer. 7. Install retaining ring (1) to drive shaft (11). NOTE: Both surfaces of spring pin (27) are parallel to each other. Install spring pin (27) while aligning the parallel surface with the groove. 2 26 27 W176-02-04-016 Parallel Surface Parallel Surface W2-6-17