hitachi — Assembly of Main Pump

BODY (UPPERSTRUCTURE) / Pump Device IMPORTANT: Do not damage the oil seal (36) sliding surface of drive shaft (11). 8. There are two ring grooves in drive shaft (11). Install retaining ring (32) to the ring groove closer to the end surface. 9. Check the direction of the inner race of roller bearing (34). Install the inner race of roller bearing (34) to drive shaft (11). 12. Assemble front casing (8) into an assembly in the following procedures. Place front casing (8) with the pump casing (2) side facing downward. Apply grease onto the inner surface of oil seal (36). Evenly tap and install oil seal (36) to front casing (8) by using a special tool and a plastic hammer.

Install retaining ring (37) to front casing (8). Turn over front casing (8). Place front casing (8) on a wooden block (120 mm (4.72 in) square or more). Install O-ring (31) to front casing (8). Install drive shaft (11) to front casing (8). At this time, roller bearing (34) can be installed by tapping drive shaft (11) lightly by using a plastic hammer. Tighten cradle plate (22) to front casing (8) with socket bolts (10) (4 used) while aligning with knock pin (35). 34 (Inner Race) 11 W4GB-02-04-004 10. Install the outer race of roller bearing (34) to drive shaft (11) with the stamped mark facing forward. 11. Install retaining ring (32) to drive shaft (11). : 6 mm :

30 N m (3.1 kgf m, 22 lbf ft) Install O-ring (30) to front casing (8). If restrictor pin (43) was removed, install backup rings (44) (2 used) and O-rings (45) (2 used) to restrictor pin (43). Install restrictor pin (43) to front casing (8). At this time, install restrictor pin (43) with the orifice side facing inside. 43 44 Cradle Plate Side Front Casing Side 45 Orifice W4GB-02-04-005 W2-6-19