hitachi — Assembly of Main Pump

BODY (UPPERSTRUCTURE) / Pump Device 13. Apply grease onto the side of the knock pin (20) hole of cam plate (19). Install cam plate (19) to swash plate (6) while aligning with knock pin (20). IMPORTANT: Install swash plate (6) with the mounting part between swash plate (6) and link pin (29) facing upward (to the regulator mounting side). 14. Apply grease onto the cylindrical surface of swash plate (6). Install cradle plate (22) to the front casing (8) assembly while aligning with the cylindrical surface. CAUTION: The front casing (8) assembly weight: 36 kg (79.5 lb) 17. Hoist the front casing (8) assembly. NOTE:

Do not tilt the casing (8) assembly as center of gravity is at the rotor (4) side. Rotor (4) comes off. IMPORTANT: Install the front casing (8) assembly so that link pin (29) can be inserted into the mounting concave part of swash plate (6) and feedback link (26). 18. Install the front casing (8) assembly to pump casing (2) while aligning with the link pin (29) position. 19. Tighten front casing (8) to pump casing (2) with socket bolts (9) (8 used). : 12 mm W176-02-04-018 15. Install the rotor (4) assembly to the front casing (8) assembly. Do not drop plunger (5) from the rotor (4) assembly. : 180 N m (18.5 kgf m, 133 lbf ft) 20.

Install O-ring (38), O-rings (40) (5 used) and spring pins (39) (2 used) to pump casing (2). CAUTION: The front casing (8) assembly weight: 36 kg (79.5 lb) 16. Raise and hold the front casing (8) assembly almost to the vertical position. W176-02-04-014 NOTE: As swash plate (6) may come off, do not raise the casing (8) assembly excessively. W2-6-21 Mounting Part to Link Pin L L