BODY (UPPERSTRUCTURE) / Pump Device Assembly of Regulator IMPORTANT: Two holes for sleeves (7, 20) on casing (9) are the same bores. In addition, the shapes of various parts are very similar. Assemble the regulator while checking the illustration in order not to confuse. IMPORTANT: Check the direction to install sleeve (7) and spool (8). 1. Insert spool (8) into sleeve (7). Install the sleeve (7) assembly to the center of casing (9) by using a round bar. 2. Install O-ring (24) to cylinder (11). 3. Insert piston (6) into cylinder (11). Install the cylinder (11) assembly to casing (9). IMPORTANT: Check the direction to install sleeve (20) and spool (19). 4. Insert spool (19) into sleeve (20).
Install the sleeve (20) assembly to the center of casing (9) by using a round bar. 5. Install O-rings (14, 16) and backup ring (15) to cylinder (18). 6. Insert piston (17) into cylinder (18). Install the cylinder (18) assembly to casing (9). 7. Install O-ring (5) and piston (6) to the stopper (4) assembly with cover (30) attached. Install the cover (30) assembly to casing (9) with socket bolts (29) (4 used). 8. Install O-ring (24) and springs (21, 22) to the stopper (23) assembly with cover (35) attached. Install the cover (35) assembly to casing (9) with socket bolts (29) (4 used). : 6 mm : 20 N m (2 kgf m, 14.5 lbf ft) : 6 mm : 20 N m (2 kgf m, 14.5 lbf ft) W2-6-25