BODY (UPPERSTRUCTURE) / Pilot Valve 11. Remove socket bolts (35) (2 used) and nuts (47) (2 used) from casings (34, 48). Separate casings (34, 48) and sub plate (41). 19. Remove detent casings (20, 44) from covers (9) (2 used). : 6 mm 12. Remove O-rings (40) (2 used) from sub plate (41). 13. Remove O-rings (40) (2 used) from casing (34). 14. Secure casings (34, 48) in a vise. Remove socket bolts (39) (4 used) from port plates (38) (2 used). NOTE: Do not drop push rod (18) which is inserted into detent bushing (15) without steel balls (16) (3 used). 20. Remove solenoids (19, 42 and 43) from detent casings (20, 44). NOTE: When removing solenoids (19, 42 and 43), do not pull a lead wire. 21.
Remove lock plugs (6) (2 used) from levers (4) (2 used). : 6 mm 15. Remove port plates (38) (2 used) and O-rings (37) (2 used) from casings (34, 48). 16. Secure plates (23) (2 used) in a vise. Remove socket bolts (1) (4 used) from the shallower hole on cove (9). : 3 mm 22. Remove camshafts (8) (2 used) from covers (9) (2 used). 23. Remove levers (4) (2 used) from covers (9) (2 used). 24. Remove nuts (2) (4 used) and screws (3) (4 used) from levers (4) (2 used). : 5 mm 17. Remove covers (9) (2 used) and detent casings (20, 44) from plates (23) (2 used). NOTE: As spring guides (21) (4 used) may be installed to detent casings (20, 24) by grease, do not drop spring guides (21) (4 used). 18.
Remove springs (22) (4 used) and spring guides (21) (4 used) from plates (23) (2 used). : 13 mm 25. Remove of an assembly detent bushings (15) (4 used), push rods (12) (3 used), push rod (18) and bushings (14) (4 used) from the mounting side by using the special tool. (Dia. 0.39 in) -0.012 -0.016 -0.3 Dia. 10 mm -0.4 (Dia. 0.32 in) -0.008 -0.012 Dia. 8 mm -0.2 -0.3 2 mm (0.079 in) W4GB-02-06-012 W2-8-9 30° 30 mm (1.18 in) 40 mm (1.58 in) (