BODY (UPPERSTRUCTURE) / Pilot Valve Assembly of Standard Pilot Valve for Front Attachment 1. Apply grease onto scrapers (17) (4 used). Install scrapers (17) (4 used) to detent bushings (15) (4 used). 4. Hold detent rings (10) (3 used) and compress springs (11) (3 used). Install steel balls (16) (12 used). NOTE: Check the direction to install scrapers (17) (4 used). NOTE: Apply grease onto steel balls (16) (12 used). Grease prevents steel balls (16) (12 used) from falling off. Thus, the installation is carried out easily. Adjust the positions of push rods (12) (3 used) so that the steel balls (16) (12 used) can be inserted into the constriction part of push rods (12) (3 used).
[A port without a detent] 5. Install push rod (18) to detent bushing (15). (Check the up and down directions of the rod.) 6. Install O-rings (13) (4 used) to covers (9) (2 used). 7. Install detent bushings (15) (4 used) to covers (9) (2 used) at the original position. 8. Temporarily tighten screws (3) (4 used) and nuts (2) (4 used) to levers (4) (2 used). 9. Apply grease onto the top and the bottom sides of push rods (12) (3 used) and push rod (18), the sliding part at the side surfaces of levers (4) (2 used) and the sliding parts of camshafts (8) (2 used). Secure covers (9) (2 used) in a vise. Install levers (4) (2 used) and camshafts (8) (2 used) to covers (9) (2 used).
15 17 W4GB-02-06-014 2. Apply grease onto the sliding parts of detent bushings (15) (3 used) and detent rings (10) (3 used). Install detent rings (10) (3 used) and springs (11) (3 used) to detent bushings (15) (3 used). [A port with a detent] 3. Install push rods (12) (3 used) to detent bushings (15) (3 used). (Check the up and down directions of the rod.) CAUTION: Prevent detent rings (10) (3 used) from flying out by springs (11) (3 used). W2-8-15