hitachi — Assembly of Standard Pilot Valve for Front Attachment

BODY (UPPERSTRUCTURE) / Pilot Valve 10. Apply LOCTITE #241 onto lock plugs (6) (2 used). Install lock plugs (6) (2 used) to lever (4). 17. Install port plates (38) (2 used) to casings (34, 48) with socket bolts (39) (4 used). : 6.9 N m (0.7 kgf m, 5.1 lbf ft) 11. Install solenoids (19, 42 and 43) to detent casings (20, 44) at the original position. : 3 mm : 20.6 N m (2.1 kgf m, 15 lbf ft) 18. Install O-rings (40) (2 used) to sub plate (41). 19. Install O-rings (40) (2 used) to casing (34). 20. Temporarily install casings (34, 48) and sub plate (41) with socket bolts (35) (2 used) and nuts (47) (2 used). Secure the casing (34, 48) parts in a vise. Tighten socket bolts (35) (2 used). :

6 mm NOTE: Insert the rubber bushing for the lead wire hole into the groove on the detent case. 12. Install detent casings (20, 44) to push rods (12) (3 used) and push rod (18) of cover (9). NOTE: Check the direction to install detent casings (20, 44). 13. Apply grease onto the attached surface of spring guides (21) (4 used). Install springs (22) (4 used) and the attached plate to plates (23) (2 used) at the original position. : 6 mm : 20.6 N m (2.1 kgf m, 15 lbf ft) NOTE: Check the mating direction of casings (34, 48) and sub plate (41). 21. Install O-rings (26) (4 used) to plugs (25) (4 used). 22. Install seals (24) (4 used) to plugs (25) (4 used). CAUTION:

Prevent springs (22) (4 used) from flying out when installing covers (9) (2 used). 14. Install covers (9) (2 used) and detent casings (20, 44) to plates (23) (2 used). Insert and temporarily tighten socket bolts (1) (4 used) into the shallower hole on covers (9) (2 used). 15. Secure plates (23) (2 used) in a vise. Tighten socket bolts (1) (4 used) to the specified torque. Spray rust proof oil inside the spring chambers in detent casings (20, 44). NOTE: Check the direction to install seal (24). 24 25 : 8.8 N m (0.9 kgf m, 6.5 lbf ft) 16. Install O-rings (37) (2 used) to casings (34, 48). : 5 mm 27 W4GB-02-06-015 W2-8-17