hitachi — Disassembly of Joy-Stick Type Pilot Valve for Additional Circuit (Optional)

BODY (UPPERSTRUCTURE) / Pilot Valve Disassembly of Joy-Stick Type Pilot Valve for Additional Circuit (Optional) IMPORTANT: Casing (18) is made of aluminium. Too strong a force can deform or damage casing (18). Be careful while handling casing (18). IMPORTANT: Spool (19) has been selected to match the hole of casing (18). The dimensions of balance springs A (3), B (4) and return springs A (5), B (6) as well as those of pushers A (9), B (10) are slightly different. Clearly identify port numbers disassembled parts. Port numbers are stamped on the outer surface of casing (18). IMPORTANT: Do not remove screw joint (17) while securing casing (18) in a vise.

The strong torque may act on screw joint (17). 1. Secure screw joint (17) in a vise. Rotate cam (16) by using a spanner. Remove screw joint (17). 3. Attach a spanner onto the upper part of universal joint (15). Remove universal joint (15). : 17 mm NOTE: Universal joint (15) is secured on casing (18) by using LOCTITE #262. 4. Remove plate (14). IMPORTANT: Do not damage the surface of sleeve (12). Insert a soft rubber between sleeve (12) and the tool. Oil seal (11) cannot be removed from sleeve (12). Sleeve (12) and oil seal (11) must be replaced as an assembly. 5. Remove sleeve (12) upward by clipping the side of sleeve (12) by using a pair of pliers. IMPORTANT:

The dimensions of pushers (9, 10) for ports (1, 3) and ports (2, 4) are different. Clearly identify port numbers of disassembled parts. 6. Remove pushers (9, 10) from casing (18). : 19 mm, 32 mm 2. Lightly secure the flat surface of casing (18) in a vise. Remove cam (16) from universal joint (15). : 32 mm W2-8-23