hitachi — Disassembly of Joy-Stick Type Pilot Valve for Additional Circuit (Optional)

BODY (UPPERSTRUCTURE) / Pilot Valve 7. Prevent the spool from lowering when compressing the spring. Install the special tool (ST 4145) to the port hole on casing (18) as illustrated. IMPORTANT: The quantity of shims (2) has been determined for each port during the performance testing at the factory. Do not lose shim (2). Keep shim (2) carefully in order to install shim (2) to the original port when assembling. 9. Remove the special tool (ST 4146). Remove spring guides (7) (4 used), return springs A (5) (2 used), return springs B (6) (2 used), balance springs A (3) (2 used) and balance springs B (4) (2 used) from spools (19) (4 used). 10.

Remove shim (2) and spacers (1) (4 used) from spools (19) (4 used). IMPORTANT: Spool (19) has been selected to match the hole of casing (18). Replace spool (19) and casing (18) as an assembly. 11. Remove the special tool (ST 4145) from casing (18). Slowly rotate and remove spool (19) from casing (18). IMPORTANT: Retaining ring (22) may come off while disassembling. Prevent retaining ring (22) from falling inside casing (18). If retaining ring (22) falls inside casing (18), remove retaining ring (22) completely. Removed retaining ring (22) cannot be reused. 12. Remove retaining ring (22) from casing (18) by using a screwdriver. Install a bolt (M8, Pitch 1.25 mm) to plug (21).

Remove plug (21) from casing (18). : 6 mm 18 W178-02-07-048 8. Install the special tool (ST 4146) to the pusher hole on casing (18). Push the special tool and compress the spring. Tighten the special tool (ST 4146) by using a socket bolt (M14, Pitch 2.0 mm). Remove retaining rings (8) (4 used) from spools (19) (4 used) by using a screwdriver. ST 4145 : 12 mm ST 4146 18 : 13 mm W178-02-07-048 W2-8-25