BODY (UPPERSTRUCTURE) / Pilot Valve Assembly of Joy-Stick Type Pilot Valve for Additional Circuit (Optional) IMPORTANT: The pilot valve is susceptible hydraulic component to contamination. Keep the parts clean when assembling. IMPORTANT: Refer to the table on the left in order to carry out assembling correctly. 3. Install spacers (1) (4 used), shim (2) and balance springs (3, 4) (2 used for each) to spools (19) (4 used). Install return springs (5, 6) (2 used for each) to casing (18). 4. Install spring guides (7) (4 used) to return springs (5, 6) (2 used for each) with the protrusion facing upward. 5. Install the special tool (ST 4146) to the pusher (9, 10) hole on casing (18).
Push the special tool (ST 4146) and compress the spring. Tighten the special tool (ST 4146) by using a bolt (M14, Pitch 2.0 mm). NOTE: The table below shows the relation between each port and component. Do not confuse them when assembling. : 12 mm ST 4146 1. Check the port hole number and insert spools (19) (4 used) into the original port. Install the thinner end of spool (19) into the port hole on casing (18) while slowly rotating. ST 4144 NOTE: Spool (19) has been selected to match the port hole. Spool (19) and casing (18) must be replaced as an assembly. 2.
Install the special tool (ST 4145) to the port hole on casing (18) in order to prevent spool (19) from lowering when pushing the spring. W178-02-07-049 6. Install retaining ring (8) to the ring holder (ST 4144). ST 4145 : 6 mm W2-8-27 Port No. Spool (19) Shim (2) Pushers A, B (9, 10) 1 Same to the original one Same to the original one Outer grooves (3 used) 2 Without outer groove 3 Outer grooves (3 used) 4 Without outer groove Port No. Return Springs (5, 6) Balance Springs A, B (3, 4) 1 Short Short 2 Long Long 3 Short Short 4 Long Long