BODY (UPPERSTRUCTURE) / Pilot Valve 7. Install retaining rings (8) (4 used) attached to the ring holder (ST 4144) to the groove on the head of spool (21) extended from the special tool (ST 4146). IMPORTANT: Check the mounting positions of pushers (9, 10) (2 used for each). 8. Install pushers (9, 10) (2 used for each). Remove pushers (9, 10) (2 used for each) after pushing several times by hand. Check if retaining ring (8) falls off or balance springs (3, 4) (2 used for each) are located correctly. After checking, install pushers (9, 10) (2 used for each) to casing (18). 9. Apply grease onto the ball part at the ends of pushers (9, 10) (2 used for each). 10.
Apply grease onto the joint part of universal joint (15). 11. Apply grease onto the inner surface of oil seals (11) (4 used). IMPORTANT: Align the bolt hole on plate (14) with the screw hole on casing (18). 14. Apply LOCTITE #262 onto the screw part of universal joint (15). Place plate (14) on casing (18). Install universal joint (15). : 17 mm : 24.5 N m (2.5 kgf m, 18 lbf ft) IMPORTANT: Check the tighteness of cam (16). 15. Install cam (16) to universal joint (15). The clearance between cam (16) and pushers (9, 10) (2 used for each) should be 0 to 0.2 mm (0 to 0.008 in). 16. Secure cam (16) by using a spanner. Tighten screw joint (17) by using a spanner. : 19 mm, 32 mm :
68.4 N m (6.98 kgf m, 50 lbf ft) NOTE: Sleeve (12) and oil seal (11) must be replaced as an assembly. 12. Install oil seals (11) (4 used) to sleeves (12) (4 used). Push the sleeve (12) assemblies (4 used) by hand until O-ring (13) is inserted into the hole on sleeves (12) (4 used). 13. Secure casing (18) in a vise lightly. W2-8-29