hitachi — Disassembly of Drive Unit

BODY (TRAVEL SYSTEM) / Drive Unit 9. Remove socket bolts (43) (4 used) at the four corners from control valve (10). Install the guides (4 used) (mounting hole: M8) at that position. 13. Remove O-ring (134) from transmission case (50). 14. Remove pump drive shaft (67) from torque converter housing (25). Removal of Speed Shift Distributor Cap 15. Secure transmission case (50) on a workbench with the torque converter side facing upward. 16. Remove bolts (36) (4 used) and washers (37) (4 used) from 3-speed/4-speed distributor cap (39). Remove distributor cap (39) from transmission case (50) by using a pulling-out bolt. : 6 mm : 17 mm IMPORTANT: Do not damage the shim. 17.

Remove shims (10 used) from torque converter housing (25). W4GC-03-02-012 CAUTION: Control valve (10) weight: 25 kg (60 lb) 10. Remove socket bolts (43) (17 used) from control valve (10). Remove control valve (10) and gasket (139) from transmission case (50). Removal of Sensor 11. Remove sensors (3) (4 used) from transmission case (50). : 6 mm : 27 mm Removal of Pump Spacer 12. Remove socket bolts (5) (6 used) from pump spacer (6). Remove pomp spacer (6) from transmission case (50). Remove orifice (140) from pump spacer (6). W4GC-03-02-018 18. Remove 1-speed/2-speed distributor cap (27) in the same way as 3-speed/4-speed speeds distributor cap (39). :

10 mm W3-2-23 Guide 43 10 27 25 him him 25