BODY (TRAVEL SYSTEM) / Drive Unit Removal of Pump Drive Gear 25. Secure torque converter housing (25) on a workbench with the side where charging pump (1) was removed facing upward. Remove retaining ring (60) from torque converter housing (25). 26. Turn over torque converter housing (25). Remove charging pump shaft (57), charging pump gear (58) and ball bearings (56, 59) from torque converter housing (25) by using a bar and a hammer. Removal of Safety Valve 27. Remove plug (132) from torque converter housing (25). Disassembly of Transmission Removal of Clutch Shaft 29. Remove shim (125) of shaft (124) from transmission case (50). 30. Remove O-rings (5 used) from transmission case (50). :
36 mm 28. Remove spring (127), spring seat (131) and ball (128) from torque converter housing (25). Remove O-ring (126) from plug (132). At this time, do not remove seat (130) of ball (128) unless any abnormality is found. When removing ball (128), do not drop ball (128) inside torque converter housing (25). W4GC-03-02-030 31. Remove the idler shaft (74) assembly from transmission case (50). IMPORTANT: Do not lose ball (120). 32. Attach a lifting tool onto shaft (124). Remove the shaft (124) assembly from transmission case (50) by using a plastic hammer. Remove reverse gear (122), ball (120) and spacer (123) from shaft (124). O-Ring O-Ring W3-2-27 50