hitachi — Disassembly of Clutch Shaft (Forward Clutch and Reverse Clutch)

BODY (TRAVEL SYSTEM) / Drive Unit Disassembly of Clutch Shaft Disassembly of Forward and Reverse Clutches 6. Turn over drum shaft (16). Apply air to the forward clutch hydraulic hole. Remove piston (10) from drum shaft (16). 7. Remove seal ring (12) from piston (10). Remove seal ring (11) from drum shaft (16). 8. Turn over drum shaft (16). Remove seal rings (14) (2 used) from the drum shaft (16) end. 9. Remove bearing (13) from drum shaft (16) by using a bearing puller. 1. Place the clutch shaft vertically with the gear side facing upward. Secure the clutch shaft on a workbench. 2. Remove bearing (13), spacer (1) and upper gear (18) from drum shaft (16) by using a bearing puller.

Remove thrust washers (2) (2 used) and thrust bearing (3) from drum shaft (16). Bearing Puller Bearing Puller W4GC-03-02-079 3. Remove gear (17) from drum shaft (16). Remove needle bearings (4) (2 used), thrust washers (2) (2 used) and thrust bearing (3) from drum shaft (16). 4. Hold end plate (6) by using a press. Remove retaining ring (5) from drum shaft (16) by using a screwdriver. 5. After loosening the press, remove end plate (6), plates (9) (11 used), discs (8) (10 used) and return springs (7) (10 used) from drum shaft (16). W4GC-03-02-086 W3-2-43 1 13 18 16 13 16