hitachi — Assembly of Drive Unit

BODY (TRAVEL SYSTEM) / Drive Unit 17. Install O-rings (5 used) to transmission case (50). 22. Turn over transmission case (50). W4GC-03-02-030 18. Install the outer races of bearings (141, 142 and 143) to the torque converter housing (25) case. 19. Apply LOCTITE FMD-127 onto the mating surface on transmission case (50). O-Ring W4GC-03-02-139 23. Install a handle to idler shaft (74). Adjust the shim between 1-speed/2-speed and 3-speed/4-speed distributor caps (27, 39) and rear case (54) so that the rolling torque within the specified range is applied to idler shaft (74). Idler only : 8.8 to 11.2 N m (0.90 to 1.14 kgf m, 6.5 to 8.3 lbf ft) Idler + F :

13.8 to 16.2 N m (1.41 to 1.65 kgf m, 10 to 12 lbf ft) Idler + F + R : 20.0 to 24.0 N m (2.04 to 2.45 kgf m, 14.5 to 17.5 lbf ft) CAUTION: The torque converter housing (25) assembly weight: 175 kg (390 lb) 20. Hoist and install torque converter housing (25) to transmission case (50) with bolts (38) (31 used). : 17 mm Handle : 34 N m (3.5 kgf m, 25 lbf ft) Rolling Torque Adjustment of Idler Shaft 21. Temporarily install 1-speed/2-speed and 3-speed/4-speed distributor caps (27, 39) to torque converter housing (25) with bolts (36) (4 used). W4GC-03-02-140 24. Remove 1-speed/2-speed and 3-speed/4-speed distributor caps (27, 39) which are installed temporarily from transmission case (50).

W3-2-71 50