BODY (TRAVEL SYSTEM) / Drive Unit Installation of Forward and Reverse Distributor Caps 25. Install O-rings (2 used) to sleeves (2 used). Apply grease onto the sleeves (2 used). Install the sleeves (2 used) and adjusted shim (69) to transmission case (50). 28. Install output shaft (99) to transmission case (50). 29. Install spacers (102, 103) to output shaft (99). 30. Install high gear (118) to 3-speed/4-speed clutch (117). 31. Install spacer (107), gear (106) and gear (105) to output shaft (99). 32. Install low gear (78) to 1-speed/2-speed clutch (113). 33. Install oil baffle (104) to transmission case (50) with bolts (2 used) and washers (2 used). 69 W4GC-03-02-141 26.
Install forward and reverse distributor caps (8, 23) to transmission case (50) with bolts (20) (8 used) and washers (21) (8 used). : 17 mm : 34 N m (3.5 kgf m, 25 lbf ft) : 19 mm : 34 N m (3.5 kgf m, 25 lbf ft) 50 34. Install the outer races of bearings (79, 119) of low gear (78) and high gear (118) to the inside of rear case (54). Bolt, Washer W4GC-03-02-142 Installation of Gear and Shaft 27. Install idler cap (72) and shim (73) to transmission case (50). Install bolts (70) (3 used) and washers (71) (3 used) to idler cap (72). W3-2-73 eve, O-Ring 5 5 0 104 50 W4GC-03- 104 104 20, 2 1