hitachi — Assembly of Drive Unit

BODY (TRAVEL SYSTEM) / Drive Unit Installation of Rear Case 35. Apply LOCTITE FMD-127 onto the mating surface on transmission case (50). 41. Apply LOCTITE #262 onto bolts (112) (3 used). Install O-ring (96) to output shaft (99). Install retainer plate (98) to output shaft (99) with bolts (112) (3 used). CAUTION: Rear case (54) weight: 50 kg (115 lb) 36. Hoist and install rear case (54) to transmission case (50) with bolts (15) (29 used) and washes (16) (14 used). : 19 mm : 135 N m (14 kgf m, 100 lbf ft) 42. Turn over transmission case (50). 43. Install seal retainer (53) to transmission case (50) with bolts (52) (4 used) and washers (135) (4 used). :

34 N m (3.5 kgf m, 25 lbf ft) Shim Adjustment of Output Shaft 37. Install seal retainer (14) to rear case (54) with bolts (12) (2 used) and washers (13) (2 used). : 17 mm : 17 mm : 91 N m (9.3 kgf m, 67 lbf ft) 44. Install flange (95) to output shaft (99). 45. Adjust the shim of output shaft (99). Measure step dimension X between flange (95) and shaft (99) without the shim. Install shim (111) so that the step is between (X+0.09) and (X±0). 46. Install O-ring (96) to output shaft (99). Install retainer plate (98) to output shaft (99) with bolts (52) (4 used) and washers (135) (4 used). : 17 mm : 34 N m (3.5 kgf m, 25 lbf ft) 38. Install flange (95) to output shaft (99). 39.

Temporarily install retainer plate (98) to output shaft (99) with bolts (112) (3 used). Raise output shaft (99) from rear case (54). 40. Adjust the shim of output shaft (99). Measure step dimension X between flange (95) and output shaft (99) without the shim. Install shim (111) so that the step is between (X+0.09) and (X±0). : 19 mm : 135 N m (14 kgf m, 100 lbf ft) W3-2-75