hitachi — Assembly of Axle

BODY (TRAVEL SYSTEM) / Axle Assembly of Axle 7. Apply LOCTITE #262 onto bolts (31) (12 used). Install plane half case (33) to flange half case (30) with bolts (31) (12 used) and washers (32) (12 used). Assembly of Differential Case (only Axle with TPD attached) 1. Install the inner race of bearing (26) to flange half case (30) by using a press. 2. Turn over flange half case (30). Align the thrust washer (34) hole (2 places) with knock pins (44) (2 used). Install thrust washer (34) to flange half case (30). 3. Install side gear (35), pinion gears (46) (4 used), thrust washers (45) (4 used) and spider (39) to flange half case (30).

Spider (39) should be pushed onto flange half case (30) by using a plastic hammer. 4. Install the inner race of bearing (26) to plane half case (33) by using a press. 5. Turn over plane half case (33). Apply grease onto thrust washer (34). Align the thrust washer (34) hole (2 places) with knock pins (44) (2 used). Install thrust washer (34) to plane half case (33). 6. Align side gear (35) with pinion gears (46) of flange half case (30). Install flange half case (30) and plane half case (33) by using a plastic hammer while aligning the matching marks. : 98 N m (10 kgf m, 72 lbf ft) 8. Install ring gear (29) to flange half case (30) by using a plastic hammer.

Temporarily tighten the flange half case (30) assembly with washers (28) (2 used) and bolts (27) (2 used) from the bottom of the flange half case (30) assembly. 9. Turn over the flange half case (30) assembly. Apply LOCTITE #262 onto bolts (27) (20 used). Install ring gear (29) to flange half case (30) with bolts (30) (20 used) and washers (28) (20 used). : 17 mm : 24 mm : 225 N m (23 kgf m, 166 lbf ft) W3-3-33