BODY (TRAVEL SYSTEM) / Axle Assembly of Differential Case (only Axle with LSD attached) 10. Install the inner race of bearing (26) to case A (74) and case B (75) by using a press. 11. Install plate (79), plates (77) (2 used), discs (78) (2 used), pressure ring (76) and side gear (80) to case B (75). 12. Install pinion gears (82) (4 used) to spider (81). Install the pinion gears (82) (4 used) assembly to side gear (80) by using a plastic hammer. 13. Install side gear (80) to pinion gears (82) (4 used). 14. Install pressure ring (76), discs (78) (2 used) and plates (77) (2 used) to case B (75). 15. Install plate (79) to case A (74). Apply grease onto plate (79).
The groove surface on plate (79) faces to the side gear (80) side.) 16. Install case A (74) to case B (75). Temporarily install case B (75) and case A (74) by using a bolt (M10, Pitch 1.5 mm) for case A (74). 17. Turn over the case A (74) assembly. Install the case A (74) assembly to ring gear (29) by using a plastic hammer. Temporarily tighten the case A (74) assembly with bolts (27) (2 used) and washers (28) (2 used) from the bottom of the case A (74) assembly. 18. Apply LOCTITE #262 onto bolts (27) (2 used). Turn over the case A (74) assembly. Install ring gear (74) to case A (74) and case B (75) with bolts (27) (20 used) and washers (28) (20 used). : 24 mm :
225 N m (23 kgf m, 166 lbf ft) : 17 mm W3-3-35