BODY (TRAVEL SYSTEM) / Axle Assembly of Bearing Cage (59) 19. Install the outer races of bearings (48, 51) to bearing cage (59) by using a press. 20. Install O-ring (60) to bearing cage (59). 21. Install the inner race of bearing (48) to pinion gear (47). 22. Install spacers (49, 50) to pinion gear (47). 23. Install bearing cage (59) to pinion gear (47). Install the inner race of bearing (51) to pinion gear (47). 24. After installing the bearing, apply load to the inner race of bearing (51) by using a hydraulic press. Measure the rotational resistance by using a spring balance. Use thread part (C) for the puller for measurement. Use a press which can provide at approx.
78 kN (7950 kgf, 57530 lbf ft). : 24 mm NOTE: The rotational resistance can also be measured by temporarily tightening flange (58) and washer (57) with bolt (56) instead of applying load by using a press. : 24 mm : 225 N m (23 kgf m, 166 lbf ft) W4GB-03-03-045 25. If the rotational resistance value is below the standard value, remove pinion gear (47). Adjust the rotational resistance value by grinding spacer (50). Rotational resistance standard value: 14.5 to 24 N m (1.5 to 2.4 kgf m, 10.5 to 17.5 lbf ft) 26. Apply LOCTITE #262 onto oil seal (53). Install oil seal (53) to bearing cage (59). 27. Apply grease onto the lip part in oil seal (53).
W3-3-37 Spring Balan hread Part (C) Spring Balan ce