BODY (TRAVEL SYSTEM) / Axle Installation of Bearing Cage (59) 36. Install to shims (61) (8 used) differential gear body (5). Install the bearing cage (59) assembly to differential gear body (5). 37. Apply LOCTITE #262 onto bolts (8) (18 used). Install the bearing cage (59) assembly to differential gear body (5) with bolts (8) (18 used) and washers (9) (18 used). 40. Set a dial gauge onto the teeth outer end of ring gear (29). Dial Gauge : 98 N m (10 kgf m, 72 lbf ft) 38. Tighten adjusting nut (62) by using the special tool (F). : 17 mm : 120 N m (12 kgf m, 89 lbf ft) W4GB-03-03-053 41. Secure pinion gear (47). Turn ring gear (29) forward and backward. Measure the backlash. 42.
If the backlash is beyond the standard value, loosen adjusting nut (62) at the plain flange half case (33) side. Tighten adjusting nut (62) at the flange half case (30) side. Move ring gear (29) close to pinion gear (47). If the backlash is less than the standard value, adjust them in the contrary way. Ring gear (29) backlash 0.25 to 0.36 mm (0.01 to 0.014 in) 43. Apply red lead primer onto 3 to 4 teeth of ring gear (29). Check the teeth contact condition while turning ring gear (29) forward and backward by hand. F 62 W4GB-03-03-051 Adjustment of Ring Gear Backlash and Ring Gear Teeth Contact Condition 39.
After adjustment, secure adjusting nuts (62) (2 used) with lock plates (63) (2 used), bolts (42) (2 used) and washers (43) (2 used). W3-3-41