hitachi — Assembly of Axle

BODY (TRAVEL SYSTEM) / Axle 44. As for the teeth contact condition adjustment, refer to the following steps a to e. After adjusting the teeth contact condition to the normal conditions, check the backlash again. c. Heel Part Contact Condition When adjusting, loosen adjusting nut (62) at the plane half case (33) side. Tighten adjusting nut (62) at the flange half case (30) side. Move ring gear (29) close to pinion gear (47). Increase the thickness of shim (61) in bearing cage (59). Move pinion gear (47) away from ring gear (29). Toe Part (Smaller End) Face W4GB-03-03-055 a. Normal Teeth Contact Condition The normal teeth contact condition is started from the toe part and is approx.

80 % length of teeth to the direction of the heel part. The adjustments of the following steps b to e are the inspections for the convex surface side of the teeth. The contact conditions are reversed on the concave side. b. Toe Part Contact Condition When adjusting, loosen adjusting nut (62) at the flange half case (30) side. Tighten adjusting nut (62) at the plane half case (33) side. Move ring gear (29) away from pinion gear (47). Reduce the thickness of shim (61) in bearing cage (59). Move pinion gear (47) close to ring gear (29). W4GB-03-03-058 d. Face Part Contact Condition When adjusting, reduce the thickness of shim (61) in bearing cage (59).

Move pinion gear (47) close to ring gear (29). Loosen adjusting nut (62) at the flange half case (30) side. Tighten adjusting nut (62) at the plane half case (33) side. Move ring gear (29) away from pinion gear (47). W4GB-03-03-059 W4GB-03-03-057 W3-3-43 art End) Fl a 47 29 47 29 47 29