BODY (TRAVEL SYSTEM) / Axle e. Frank Part Contact Condition When adjusting, increase the thickness of shim (61) in bearing cage (59). Move pinion gear (47) away from ring gear (29). Loosen adjusting nut (62) at the plane half case (33) side. Tighten adjusting nut (62) at the flange half case (30) side. Move ring gear (29) close to pinion gear (47). 47. Apply LOCTITE #262 onto button bolts (38) (8 used). Install springs (36) (8 used), adapters (37) (8 used) and button bolts (38) (8 used) to differential gear body (5). : 49 N m (5 kgf m, 108 lbf ft) 48. Install shaft (40) to side gear (35). 49. Install pins (22) (2 used) to the lower part of differential gear body (5).
Install brake ring (20) while aligning with pins (22) (2 used). 50. Install brake disc (19) and brake ring (64) to differential gear body (5). 51. Install second brake disc (19) so that the open hole of second brake disc (19) is alighed with the open hole of first brake disc (19). 52. Install brake ring (20) and end plate (21) to differential gear body (5) in this order. 53. Install pins (22) (6 used) to differential gear body (5) by using a plastic hammer. 54. Install the brake on the opposite side in the same way. Assembly of Axle Tube 55. When replacing ring gear (66), install ring gear (66) to axle tube (2) with pins (3) (4 used) by using a plastic hammer. :
6 mm W4GB-03-03-060 Installation of Brake 45. Install D-rings (23, 24) to brake piston (25). 46. Install brake piston (25) to differential gear body (5) with a thrust bolt by using plate (G). W3-3-45 47 29 Thrust Bolt Plate (G) 5 25 W4GB-03-0