hitachi — Assembly of Axle

BODY (TRAVEL SYSTEM) / Axle 64. Install selected shim (67) and retainer plate (89) to axle shaft (73). Install retainer plate (89) to axle shaft (73) with bolt (70). 69. Install steel ball (88) to planet shaft (84). Install planet shaft (84) to planet carrier (91). 70. Align the notch of retaining ring (90) and the steel ball (88) mounting groove. Install retaining ring (90) to the groove on planet carrier (91). : 36 mm : 49 N m (5 kgf m, 36 lbf ft) 65. Attach a spring balance onto knock pin (65) of axle tube (2). Pull a spring balance on the mounting pitch circle and measure the rotational resistance of bearing (69).

If the measurement value is out of the range from 20 to 39 N (2 to 4 kgf, 4.5 to 8.78 lbf), perform the shim adjustment again. If the measurement value is less than the range, reduce the shim thickness. On the contrary, if the measurement valve is beyond the range, increase the shim thickness. 91 90 S 65 W4GB-03-03-073 90 Steel Ball (88) Mounting Groove 2 W4GB-03-03-068 66. Remove retainer plate (89) and bolt (70). Remove planet carrier (91) from axle tube (2). : 36 mm Viwe S CAUTION: Planet carrier (85) weight: 25 kg (60 lb) Assembly of Planet Carrier Assembly (68) 67. Install the outer race of bearings (86) (2 used) to planet gear (85).

Install collar (83) and the inner race of bearing (86) to planet gear (85). 68. Install thrust washers (87) (2 used) to planet carrier (91). At this time, set the stopper of thrust washer (87) to the groove on the outer surface of planet carrier (91). W4GB-03-03-074 71. Install retainer plate (89) to planet carrier (91). Install other planet gears (85) (2 used) to planet carrier (91) in the same way. W3-3-49