BODY (TRAVEL SYSTEM) / Propeller Shaft Removal of Propeller shaft (Front) 1. Remove grease fitting (3) in order to drain the internal grease. IMPORTANT: Do not separate and remove propeller shaft assembly (6). If separating and removing it, spline seal (4) may be damaged. Remove it as an assembly. 2. Remove bolts (1, 5) (4 used for each) from propeller shaft assembly (6). Installation of Propeller Shaft (Front) IMPORTANT: Align the flanges of the propeller shafts at the front and the rear. Install the propeller shafts at the front and the rear with the grease fitting surfaces facing to the same side. At this time, raise the body so that the tires can be rotated. (Refer to W3-4-1.) 1.
Install support bearing (2) to the body with bolts (7) (2 used), nuts (8) (2 used) and washers (9) (4 used). : 17 mm 3. Remove bolts (7) (2 used), nuts (8) (2 used) and washers (9) (4 used) from support bearing (2). : 30 mm : 196.2 to 215.8 N m (20 to 22 kgf m, 145 to 159 lbf ft) 2. Apply LOCTITE #262 onto bolts (1, 5) (4 used for each). 3. Install bolts (1, 5) (4 used for each) to propeller shaft assembly (6). : 30 mm CAUTION: Propeller shaft assembly (6) weight: 47 kg (105 lb) 4. Remove propeller shaft assembly (6) from the body. : 143 N m (15 kgf m, 105 lbf ft) 4. Install grease fitting (3). Apply grease. : 17 mm W3-4-3