hitachi — Removal and Installation of Propeller Shaft

BODY (TRAVEL SYSTEM) / Propeller Shaft Removal of Propeller Shaft (Rear) 1. Remove grease fitting (2) in order to drain the internal grease. 2. Remove bolts (1, 3) (4 used for each) from propeller shaft assembly (4). Installation of Propeller Shaft (Rear) IMPORTANT: Apply LOCTITE #262 onto the mounting bolts. IMPORTANT: Align the flanges of the propeller shafts at the front and the rear. Install the propeller shafts at the front and the rear with the grease fitting surfaces facing to the same side. At this time, raise the body so that the tires can be rotated. (Refer to W3-4-1.) IMPORTANT: Install propeller shaft assembly (4) with the spline shaft side facing to the transmission side. 1.

Install bolts (1, 3) (4 used for each) to propeller shaft assembly (4). : 17 mm CAUTION: Propeller shaft assembly (4) weight: 16 kg (12 lb) 3. Remove propeller shaft assembly (4) from the body. : 143 N m (15 kgf m, 105 lbf ft) 2. Install grease fitting (2). Apply grease. : 17 mm W3-4-5