BODY (TRAVEL SYSTEM) / Brake Valve 11. Remove socket bolts (33) (3 used) and spring washers (32) (3 used) from mounting plate (31). Remove mounting plate (31) from cover (24). IMPORTANT: When input spool (25) is secured in a vise, prevent the outer diameter of input spool (25) from damaging by using a protective material. 18. Remove socket bolt (21) from input spool (25). Remove retainer (22), spring (20) and spring seat (23) from cover (24). : 6 mm 12. Remove dust cover (29) and seat (30) from input spool (25). 13. Remove socket bolts (13) (4 used) from body (12). Divide into bodies (5, 12) and cover (24). Remove springs (10, 17, 19) and spring seat (18) from bodies (5, 12). : 4 mm :
6 mm 14. Place body (12) on a stand with the body (5) side facing downward. Remove C-ring (16), plug (15) and spring (10) from body (12). Remove O-ring (14) from plug (15). 15. Remove spools (1) (2 used) from bodies (5, 12). Remove plungers (2) (2 used), retaining ring (9) (2 used), spring seats (8) (2 used), orifices (4, 11) and O-rings (3) (2 used) from bodies (5, 12). : 5 mm 16. Remove input spool (25) with the spring attached from cover (24). 17. Place cover (24) on the stand with the body (5) side facing downward. Remove C-ring (28) from cover (24). Remove stopper (27) and oil seal (26) from cover (24). W3-5-9