BODY (TRAVEL SYSTEM) / Brake Valve Assembly of Brake Valve 1. Install orifice (11) to body (12). Install orifice (4) to body (5). 8. Insert socket bolts (13) (4 used) into body (12). Place body (12) on a level stand. Install spring (10) to spool (1). 9. After checking the port direction, install body (5) to body (12) while inserting body (5) into socket bolts (13) (4 used). 10. Apply grease onto the lip inner surface, the outer surface of oil seal (26) and the inner surface of the oil seal groove. Install oil seal (26) to cover (24). Install stopper (27) and C-ring (28) to cover (24). : 9.8 to 14.7 N m (1 to 1.5 kgf m, 7.2 to 11 lbf·ft) 2.
Install spring seats (8) (2 used) and retaining rings (9) (2 used) to spools (1) (2 used). 3. Insert plungers (2) (2 used) into spools (1) (2 used). 4. Insert spools (1) (2 used) into bodies (5, 12) respectively. 5. Install O-ring (14) to plug (15). IMPORTANT: Check that spring (10) is completely installed in the hole on spring seat (8) and plug (15). 6. Install spring (10), plug (15) and C-ring (16) to body (12). 7. Install O-rings (3) (2 used) to bodies (5, 12). : 5 mm Dia. 40 mm (1.58 in) 26 W4GB-03-05-003 Dia. 22.4 mm (0.88 in) W3-5-13