hitachi — Assembly of Brake Valve

BODY (TRAVEL SYSTEM) / Brake Valve IMPORTANT: When input spool (25) is secured in a vise, prevent the outer diameter of input spool (25) from damaging by using a protective material. 11. Install spring seat (23), spring (20) and retainer (22) to input spool (25) with socket bolt (21). At this time, install spring (20) with the small diameter side facing to the retainer (22) side. : 4 mm : 6.86 to 8.83 N m (0.7 to 0.9 kgf m, 5.1 to 6.5 lbf ft) 12. Apply grease onto the outer surface of input spool (25). Insert input spool (25) into cover (24). IMPORTANT: Check that spool (1) is completely installed in the hole on spring seat (18).

Insert spring (19) into the hole on spring seats (18, 23) and spring (17) into the hole on bodies (5) and spring seat(23). 13. Install springs (17, 19) and spring seat (18) to cover (24). Check the port direction and install the cover (24) assembly to body (5) with socket bolts (13) (4 used). : 6 mm : 19.6 to 25.5 N m (2 to 2.6 kgf m, 14.5 to 19 lbf ft) W3-5-15