hitachi — Assembly of Brake Valve

BODY (TRAVEL SYSTEM) / Brake Valve 14. Install seat (30) and dust cover (29) to input spool (25). 15. Install mounting plate (31) to cover (24) with socket bolts (33) (3 used) and washers (32) (3 used). 21. Apply grease onto the contacting surface between seat (30) and roller (37). As for pedal (38) at the left side, adjust screw (44) and tighten nut (43) so that the clearance between seat (30) and roller (37) is 0.5 mm (0.02 in) or less. : 12 mm : 6 mm : 7.85 to 11.8 N m (0.8 to 1.2 kgf m, 5.8 to 8.7 lbf ft) 22. Install cover (39) to pedal (38) at the left side. : 19.6 to 25.5 N m (2 to 2.6 kgf m, 14.5 to 19 lbf ft) 16. Install shafts (53, 57) to joint (56) with pins (47) (2 used). 17.

Apply molybdenum disulfide grease onto joint (56). Install boot (55) to joint (56) with retaining rings (54) (2 used). 18. Apply grease onto the inner surface of roller (37) and the outer surface of pin (35). Install roller (37), collars (36) (2 used), pin (35), L pin (34), washer (40) and pin (41) to pedal (38) at the left side. 19. Apply grease onto the inner surface of bushings (51) (2 used) and the outer surface of shaft (57). Install bushings (51) (2 used) to mounting plate (31). Install pedal (38) at the left side, collar (52) and shaft (57) to mounting plate (31) with bolt (42), washer (45) and nut (46). : 14 mm : 29.4 to 34.3 N m (3 to 3.5 kgf m, 21.5 to 25 lbf ft) 20.

Temporarily install screw (44) and nut (43) to pedal (38) at the left side. W3-5-17