BODY (TRAVEL SYSTEM) / Steering Pilot Valve Disassembly of Steering Pilot Valve IMPORTANT: Attach a cloth to the open end of a vise and hold the steering pilot valve lightly. Do not hold it too strong. 1. Secure housing (8) with the cap (21) side facing upward in a vise. IMPORTANT: Wear a pair of protective glasses as retaining ring (2) may fly out from housing (8). 5. Remove housing (8) from the vise. Turn over housing (8). Remove ball (22). Place the housing (8) assembly on a clean cloth in order not to damage the finished surface. Remove retaining ring (2) from housing (8) by using a screwdriver. 21 Vise NOTE: Do not drop or lose ball (22).
Check the hole position where ball (22) was installed. 8 W202-02-14-002 2. Remove screws (25) (6 used) and screw (24) from cap (21). Remove cap (21) from housing (8). Remove O-ring (16) from cap (21). : 5/16 inch 3. Remove rotor (18) from housing (8). Remove O-ring (16) and spacer (20) from rotor (18). W202-02-14-006 6. Rotate spool (13) and sleeve (9), and set pin (10) horizontally. Push spool (13) and sleeve (9) from the cap (21) side. Remove bushing (3) from housing (8). NOTE: Do not drop star (19) when removing rotor (18). 4. Remove drive (17) and plate (15) from housing (8). Remove O-ring (14) from housing (8). Remove screw (23) from housing (8) by using a screwdriver. W3-7-5 8 2 2