BODY (TRAVEL SYSTEM) / Steering Pilot Valve Assembly of Steering Pilot Valve IMPORTANT: Set the spring grooves on spool (13) and sleeve (9) to the same side. 1. Install spool (13) to sleeve (9) by rotating. Align the matching marks on spool (13) and sleeve (9). 3. Insert pin (10) into the holes on spool (13) and sleeve (9). Align both ends of pin (10) with the outer diameter surface of sleeve (9). 13 Spring Groove 9 10 W202-02-14-021 4. Insert the sleeve (9) assembly from the cap (21) side of housing (8). W202-02-14-019 IMPORTANT: Wear a pair of protective glasses as center spring (11) and flat spring (12) may fly out. 2.
Align the spring groove positions of spool (13) and sleeve (9), and place them on a flat plate. Set center springs (11) (2 used for each) back-to-back. Set flat springs (12) (2 used) at the center position. Install center springs (11) (4 used) and flat springs (12) (2 used) to the special tool (ST 2497). Install center springs (11) (4 used) and flat springs (12) (2 used) to the spring grooves on spool (13) and sleeve (9) by using the special tool (ST 2497). Matching Mark NOTE: When inserting the sleeve (9) assembly, do not get caught in housing (8). Rotate pin (10) to the right and the left while holding pin (10) horizontally.
Insert pin (10) until both rear end surfaces of the sleeve (9) assembly and housing (8) are located at the same position. W4GB-03-07-003 W3-7-9 13 ST2497 9 11 12 11 11 12 11