BODY (TRAVEL SYSTEM) / Steering Pilot Valve 11. Rotate the sleeve (9) assembly and set pin (10) and the port surface of housing (8) in parallel. Put line B onto the spline side end so that line B is parallel to line C on the yoke part of drive (17). Insert drive (17). Assemble the yoke part of drive (17) and pin (10). Set line B on the spline side end in drive (17) and the port surface of housing (8) in parallel. 14. Insert spacer (20) into rotor (18). Install O-ring (16) to cap (21). Place cap (21) on rotor (18). 15. Install cap (21) to housing (8) with screws (25) (6 used) and screw (24). : 5/16 inch :
23 N m (2.3 kgf m, 17 lbf ft) Line B Root 18 A 19 B 17 Bolt Hole 17 C W487-03-08-006 15 D 12. Install O-ring (16) to rotor (18). 13. Face the O-ring (16) side of rotor (18) to the plate (15) side. Install star (19) while aligning the splines of star (19) and drive (17) so that line A connecting the concave parts of star (19) is parallel to line B on drive (17). Check that the lines A, B, C and D are in parallel as illustrated in the right. Align the bolt holes on rotor (18) while mating drive (17) and star (19). W202-02-14-031 10 Port Surface W3-7-13 Yoke Part Port Surface 17 Set pin (10) and port surface in p 10 Port Surface York Part 8 Set pin (10) and port surface in p the arallel.