hitachi — Disassembly of Steering Valve

BODY (TRAVEL SYSTEM) / Steering Valve Disassembly of Steering Valve IMPORTANT: Do not disassemble relief valve (1) as relief valve (1) has been set at the set pressure. 1. Remove relief valves (1) (2 used) from valve housing (17). 5. Secure the spool (19) assembly by using wooden pieces in a vise in order not to damage the outer surface of the spool (19) assembly. Remove cap screws (12) (2 used), springs (15) (2 used) and poppets (16) (2 used) from the spool (19) assembly. : 32 mm 2. Remove plug (2) from valve housing (17). Remove O-ring (3) from plug (2). : 17 mm : 36 mm IMPORTANT: When removing cap (18) and cap assembly (7), prevent spring (10) from flying out.

As the steel ball is installed to cap assembly (7), replace as an assembly. As sleeve assembly (5) is installed by crimping the filter, replace as an assembly. 3. Remove socket bolts (6) (4 used) from cap (18) and cap assembly (7). Remove cap (18), cap assembly (7), springs (10) (2 used) and spring seats (11) (2 used) from valve housing (17). Remove O-rings (9, 8, 4) from cap (18). Remove O-rings (9, 8, 4) and sleeve assembly (5) from cap assembly (7). W4GB-03-08-002 6. Remove O-rings (14) (2 used) and backup rings (13) (2 used) from cap screws (12) (2 used). : 6 mm IMPORTANT: Do not damage spool (19) when removing.

Put the matching marks in order not to confuse the inserting direction when assembling. 4. Remove the spool (19) assembly from valve housing (17) by rotating. W3-8-5 30 to 40 mm (1. 18 to 1.58 in) 10.5 to 12 mm (0.41 to 0.47 in) 70 (2. to 100 mm 76 to 3.94 in)