hitachi — Disassembly of Steering Cylinder

BODY (TRAVEL SYSTEM) / Steering Cylinder IMPORTANT: Loosen set screw (9) after cutting the crimped part (2 places) by using a hand drill. 4. Secure piston rod (10) horizontally. Remove set screw (9) from piston nut (5). IMPORTANT: Do not damage the seal groove by a cutting tool. 9. Place piston (3) on a stable V-shaped stand. Remove the backup rings at both sides of packing (2) from piston (3). Cut and remove the seal ring and the back ring in the center part of packing (2) by using a hammer and a screwdriver. : 4 mm 5. Remove piston nut (5) from piston rod (10) by using a special tool. NOTE: As for the special tool, refer to W3-9-20. 6.

Install the pins (Diameter 8 mm, Length 25 mm) in to the end (2 places) of piston (3). Remove piston (3) from piston rod (10) by using the special tool. NOTE: As for the special tool, refer to W3-9-20. 7. Remove rod cover (15) from piston rod (10). 8. Remove wear ring (4) and dust ring (1) from piston (3). W4GB-04-02-004 10. Remove O-ring (23) and backup rings (22) (2 used) in piston (3) by using a spatula. W4GB-04-02-005 11. Place rod cover (15) on the workbench which is covered with an anti-skid waste cloth. 12. Remove O-rings (17, 18), backup ring (19) and lock washer (16) from rod cover (15). W3-9-9 Hammer Screwdriver Detail Seal Ring Back Rin Seal Ring Back Rin g Spatula 23 22 3