BODY (TRAVEL SYSTEM) / Steering Cylinder 16. Apply hydraulic oil onto O-ring (23) and the thread part of the piston (3) bore part. Install the pin (Diameter 8 mm, Length 25 mm) to the screw hole on the piston (3) end. Install piston (3) to piston rod (10) by using the special tool. 20. Apply hydraulic oil onto the packing parts. Tighten rod cover (15) to cylinder tube (8) by using a hooked spanner. Bend the lock washer in order not to loosen. Lock cover (15) diameter: 84 mm (3.31 in) : 490±49 N m (50±5 kgf m, 360±36 lbf ft) : 490±49 N m (50±5 kgf m, 360±36 lbf ft) NOTE: As for the special tool, refer to W3-9-20. 17. Apply hydraulic oil onto the thread part of piston nut (5).
Install piston nut (5) to rod (10) by using the special tool. Hooked Spanner : 490±49 N m (50±5 kgf m, 360±36 lbf ft) NOTE: As for the special tool, refer to W3-9-20. 18. Apply LOCTITE #242 onto the thread part of set screw (9). Install set screw (9) to piston nut (5). Crimp set screw (9) by using a punch (2 places). : 4 mm : 15±1.5 N m (1.5±0.15 kgf m, 11±1.1 lbf ft) 19. Apply hydraulic oil onto the packing parts. Secure cylinder tube (8) in a vise horizontally. Insert piston rod (10) into cylinder tube (8). W506-04-02-019 15 W3-9-19