hitachi — Removal and Installation of Front Attachment

FRONT ATTACHMENT / Front Attachment 2. Install spacers (15) (4 used) to the pin (3) hole on lift arm (14). Install pins (3) (2 used) to the front frame with spring washers (5) (2 used), washers (4) (2 used) and bolts (6) (2 used). CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. IMPORTANT: Check for the outer and inner diameters, wear and damage of all pins and bushings before installation. If any damage is found, replace the parts. (Refer to OPERATIONAL PERFORMANCE TEST.) IMPORTANT: When installing the pin, apply grease onto the inside of the bushing and the dust seal.

Apply the rust-inhibiting oil onto the inside of the boss. IMPORTANT: Install the bushing as illustrated bellow. : 87 N m (8.9 kgf m, 64 lbf ft) 3. Hoist lift arm (14). Align the pin (24) holes on lift arm (14) and lift arm cylinder (20). 4. Install spacers (25) (4 used) to the pin (24) holes (2 used) on lift arm (14). Install pins (24) (2 used) to lift arm cylinder (20) with spring washers (22) (2 used), washers (23) (2 used) and bolts (21) (2 used). : 24 mm : 24 mm : 87 N m (8.9 kgf m, 64 lbf ft) W4GB-04-01-018 CAUTION: Lift arm (14) weight: 1150 kg (2550 lb) 1. Hoist and align pin (19) in lift arm (14) with the pin (3) hole on the front frame.

W4GB-04-01-007 W4-1-9 3 19 14 Front Fram 24 20 Front Fram e