FRONT ATTACHMENT / Cylinder IMPORTANT: Do not damage the seal groove by a cutting tool. 10. Place piston (3) on a V-shaped stable stand. Remove the backup rings at both sides of packing (2) from piston (3). Cut and remove the seal ring and the back ring in the center part of packing (2). 13. Remove O-rings (14, 15) and backup ring (13) from rod cover (16). W4GB-04-02-006 14. Remove U-packing (18) and buffer seal (17) from the inside of rod cover (16) by using an awl. Awl 16 18 W4GB-04-02-004 11. Remove O-ring (9) and backup rings (8, 10) from piston (3) by using a spatula. 17 W4GB-04-02-007 15. Remove retaining ring (20) from rod cover (16). 16. Remove dust seal (19) from rod cover (16).
W4GB-04-02-005 12. Place rod cover (16) on the workbench which is covered with an anti-skid waste cloth. Vise W4GB-04-02-009 IMPORTANT: Do not remove rod bushing (12) unless necessary. 17. Remove retaining ring (11) and rod bushing (12) from rod cover (16). 16 W4-2-9 13 14 patula 1 1 14 1 5 1 6 Hammer Screwdriver Detail Seal Rin g Back Rin g 9 Spatula 10 3 8 3 Hammer S crewdriver mer 1 9