hitachi — Assembly of Lift Cylinder

FRONT ATTACHMENT / Cylinder 8. Install a special tool to piston (3). Install the back ring of packing (2) to piston (3). 12. Install the backup ring to both sides of the seal ring of packing (2). NOTE: As for the special tool, refer to W3-9-21. Backup Ring R R Back Ring Seal Ring Direction of Packing (2) Parts W4GB-04-02-020 13. Secure piston rod (21) on a workbench horizontally. 14. Install wear ring (4) and dust ring (1) to piston (3). Apply hydraulic oil onto piston (3). W4GB-04-02-018 IMPORTANT: Warm up the seal ring of packing (2) in the oil heated by an electric air heater. Avoid direct-heating by fire. 9. Warm up the seal ring of packing (2) to 150 to 180 °C (300 to 370 °F).

Install the seal ring of packing (2) to the seal groove on piston (3). 10. Adjust the extended seal ring of packing (2) by using a special tool. NOTE: Do not drop wear ring (4) and dust ring (1). 3 W4GD-04-02-005 15. Apply hydraulic oil onto a special tool and the piston rod (21) surface. Install rod cover (16) to piston rod (21) by using the special tool. NOTE: As for the special tool, refer to W3-9-21. NOTE: As for the special tool, refer to W3-9-23. W4GB-04-02-019 11. Install O-ring (9) and backup rings (8, 10) to piston (3). 8 9 3 10 W4GD-04-02-005 W4-2-13 Special Tool Seal Ring Packing (2 Back Ring 3 Seal Ring Packing (2 of ) Back Ring 4 Special Tool