FRONT ATTACHMENT / Cylinder 16. Apply hydraulic oil onto O-ring (9) and the thread part of piston (3). Install a bolt (M10, Length 20 mm) to the screw hole on the piston (3) end. Install piston (3) to piston rod (21) by using a special tool. 19. Secure cylinder tube (6) in a vise horizontally. Insert piston rod (21) into cylinder tube (6). 20. Apply LOCTITE #242 onto the thread part of socket bolts (22) (12 used). Install rod cover (16) to cylinder tube (6) with socket bolts (22) (12 used). : 980±98 N m (100±10 kgf m, 720±7.2 lbf ft) NOTE: As for the special tool, refer to W3-9-20. 17. Apply hydraulic oil onto the thread part of piston nut (5).
Install piston nut (5) to piston rod (21) by using a special tool. : 225 to 235 N m (23 to 24 kgf m, 166 to 175 lbf ft) 21. Add the low-pressure air to the port in the piston rod (21) side of cylinder tube (6). Retract piston rod (21). : 12 mm : 1860±186 N m (190±19 kgf m, 1370±137 lbf ft) NOTE: As for the special tool, refer to W3-9-20. 18. Apply LOCTITE #242 onto the thread part of set screw (7). Install set screw (7) to piston nut (5). Crimp set screw (7) by using a punch (2 places). : 4 mm : 15±1.5 N m (1.5±0.15 kgf m, 11±1.1 lbf ft) W4-2-15