hitachi — Disassembly of Bucket Cylinder

FRONT ATTACHMENT / Cylinder Disassembly of Bucket Cylinder The disassembling procedure starts on the premise that the hydraulic piping and the bands securing the piping have been removed. IMPORTANT: Loosen set screw (16) after cutting the crimped part (2 places) by using a hand drill. 5. Secure piston rod (21) horizontally. Remove set screw (7) from piston nut (6). CAUTION: Bucket cylinder weight: 140 kg (310 lb) 1. Hoist and place the cylinder on a workbench horizontally. Drain hydraulic oil from the cylinder. : 4 mm 6. Remove piston nut (6) from piston rod (21) by using a special tool. NOTE: As for the special tool, refer to W3-9-20. 7.

Install a bolt (M12, Pitch 1.75 mm) to the piston (3) end (2 places). Remove piston (3) from piston rod (21) by using a special tool. NOTE: As for the special tool, refer to W3-9-20. 8. Remove rod cover (23) from piston rod (21). 9. Remove wear ring (4) and O-ring (5) from piston (3). W102-04-02-027 2. Remove socket bolts (22) (14 used) from rod cover (23). : 14 mm 3. Tighten set screw (16) installed to the flange part of rod cover (23) and make clearance between the mating surfaces. Remove rod cover (23) from cylinder tube (8) by using a screwdriver. : 6 mm 4. Remove the piston rod (21) assembly from cylinder tube (8). W4-2-17