hitachi — Disassembly of Center Hinge

BODY (UPPERSTRUCTURE) / Center Hinge Disassembly of Center Hinge 2. Remove bolts (2) (3 used), bolts (1) (4 used) and washers (3) (7 used) from flange (4). Remove flange (4), shims (5) (2 used) and pin (14) from rear frame (28). CAUTION: The center hinge is required to disassemble for the major maintenance work such as removal of the front frame from the rear frame. At this time, move the machine into the factory. Preparation When disassembling the center hinge, set the machine to the following conditions. 1. Remove the cap and the cockpit. 2. Remove the connecting parts between the front frame and the rear frame.

Propeller Shaft Steering Cylinder Hydraulic Hose Brake Piping Harness Removal of Hinge Pin 1. Support the front frame and the rear frame by using the solid support. : 24 mm 3. Remove bolt (15) and washers (16, 17) from pin (18). Remove pin (18) from rear frame (28). : 24 mm 4. Remove bushing (9) from front frame (27). (Remove bushing (9) after cutting by gas or using arc welding.) CAUTION: Front frame (27) weight: 1130 kg (2500 lb) 5. Attach a nylon sling onto front frame (27). Hoist front frame (27). Remove front frame (27) from rear frame (28). 6. Remove bushing (13) from front frame (27). 7. Remove bolts (6) (6 used) from cap (7).

Remove caps (7, 12) and shims (8) (2 used) from front frame (27). : 17 mm 8. Remove dust seals (10) (2 used) from caps (7, 12). 9. Remove bearing (11) from front frame (27). W4GB-02-03-002 W2-3-3