BODY (UPPERSTRUCTURE) / Center Hinge Assembly of Center Hinge IMPORTANT: Check the direction of dust seal (23). Install dust seal (23) with the wider rubber side facing to the unpainted surface of caps (21, 25). 1. Apply LOCTITE #262 onto the outer surface of dust seals (23) (2 used). Lightly tap and insert dust seal (23) into cap (21) by using a hammer. Wipe out the stick-out LOCTITE #262 by using a waste. Install dust seal (23) to cap (25) in the same way. 7. Install shims (8) (2 used) to the upper hinge part of front frame (27). Apply LOCTITE #262 onto bolts (6) (6 used). Install caps (7, 12) to front frame (27) with bolts (6) (6 used). : 88 N m (9 kgf m, 65 lbf·ft) 8.
Tap the position between caps (7, 12) and dust seals (10) (2 used) by using an iron nail. 9. Install shims (22) (2 used) to the lower hinge part of front frame (27). Apply LOCTITE #262 onto bolts (20) (6 used). Install caps (21, 25) to front frame (27) with bolts (20) (6 used). : 17 mm 21, 25 23 : 88 N m (9 kgf m, 65 lbf·ft) 10. Tap the position between caps (21, 25) and dust seals (23) (2 used) by using an iron nail. : 17 mm Face the lip to the outside (painted surface of the cap) W4GB-02-03-005 2. Install dust seals (10) (2 used) into caps (7, 12) in the same way. 3. Insert bearing (11) into the upper hinge part of front frame (27). 4.
Add grease through grease fitting (26) into the inside of bearing (11) while rotating bearing (11). 5. Insert bearing (24) into the lower hinge part of front frame (27). 6. Add grease through grease fitting (26) into the inside of bearing (24) while rotating bearing (24). W2-3-7