Kubota — Checking Water Separator

51 Check Hydraulic Oil Level 3 CAUTION To avoid personal injury: First lower all attachments on the ground then stop the engine and remove the key. 4. Should the oil level be too low, fi ll oil through the oil port before starting the engine. This step is important for the protection of the hydraulic system. IMPORTANT: Before fi lling oil, wipe away all sand and dust from around the oil port. Make sure you use an identical type of hydraulic fl uid. The excavator has been fi lled with hydraulic fl uid before delivery. See “RECOMMENDED OILS”. (Do not mix different oils!) (1) Specifi ed oil level (2) Tank cap 1. Park the excavator on a fi rm, fl at and level surface.

Adjust the swing angle to the center. Pull in the arm completely. Pull in the bucket completely. Lower the attachments and dozer blade to the ground and stop the engine. Track width increases [16 in. (1240 mm)]. Checking water separator 1. Open the engine bonnet. 2. When the separated water is being drained, the red fl oat moves upward. When the red fl oat has reached the indication line, close the cock so that no fuel can run out. Now loosen the ring nut, remove the cup, empty the cup and clean the cup. 3. Place the cup back into position. Bleed the fuel system. 4. Finally, do not forget to open the cock. 2.

Check the oil level as to whether it lies on the center of the gauge at normal temperature (10 to 30єC). 3. Enough oil is present if the oil level lies between the markings. (1) Ring nut (A) “Open” (2) Float (B) “Closed” (3) Cup (4) Cock (5) Indication line