Kubota — Lifting Capacity

80 LIFTING CAPACITY 1. The lifting capacities are based on ISO 10567 and do not exceed 75% of the static tilt load of the machine or 87% of the hydraulic lifting capacity of the machine. 2. The strokes are as follows. 1) The load point corresponds to the front bolt part of the arm. 2) The machine positions are (i) over – front (Blade up), (ii) over – front (Blade down), and (iii) over – side. 3) The operating cylinder is the boom cylinder. 3. The bucket of the excavator, the hook, the sling and other lifting accessories are taken into consideration for the loads. Machine conditions: No bucket, all others according to the standard regulations. 3 WARNING To avoid personal injury or death:

It is forbidden to lift loads greater than those values mentioned in the lifting capacity tables. The values mentioned in the table are valid only on even, hard grounds. When lifting on soft ground, the machine 'can tilt over due to the fact that the load is concentrated only on one side of the machine. The table values are calculated at the end of the arm without the bucket. In order to fi nd the allowable loads for machines with bucket, the bucket weight must be subtracted from the values in the table. 3 WARNING To avoid personal injury or death: In this manual, the machine's lifting capacity is discussed, but it does not mean that it is recommended to use the machine for lifting jobs.

It is specifi ed in item 3.4 of ISO 10567:1992 that the following devices must be additionally installed if a hydraulic excavator with the rated lift load of over 2,205 lbs (1,000 kg) at its minimum lifting radius or the tilting moment of over 29,504 ft-lbs (40,000 N-m, 4,082 kg-m) is used for lifting loads. (1) Lifting hook (2) Acoustic alarm or warning lamp for the operator when the rated load or the corresponding tilting moment has been exceeded. (3) Boom decending control device comforming to ISO 8643:1997