Komatsu — 6.8.2 INSTALLING AND CONNECTING THE EQUIPMENT

ARRANGEMENT FOR THE OPERATION OF OPTIONAL EQUIPMENT WITH UNIDIRECTIONAL OIL FLOW 6.8 ARRANGEMENT FOR THE OPERATION OF OPTIONAL EQUIPMENT WITH UNIDIRECTIONAL OIL FLOW DANGER Some equipment that can be installed instead of the standard bucket make the machine unsuitable for travelling on roads. Before travelling on roads, always make sure that the machine is homologated for travelling with the equipment with which it is provided. The installation and removal of the equipment that is not homologated for travelling on roads must be carried out at the work site or in any case in delimited spaces with no traffic.

6.8.1 DESCRIPTION AND CONTROL The machine can be provided with an independent hydraulic cir- cuit in order to permit the operation of optional equipment that can be installed on the backhoe instead of the standard bucket. The circuit is operated through an additional hydraulic distributor controlled by a pedal positioned on the left side of the backhoe control lever unit. The controls that operate the additional circuit are the following: RIGHT SIDE PRESSURE 1 - When the pedal (1) is pressed with the toe, the oil is delivered to the right side of the circuit and returns from the left side.

LEFT SIDE PRESSURE 2 - When the pedal (1) is pressed with the heel, the oil is deliv- ered to the left side of the circuit and returns from the right side. The levers maintain the functions described at point “3.3.5 (pos. 15-16) BACKHOE CONTROL LEVERS”) unchanged, exception made for the movement of the bucket control, which serves for the positioning of the optional equipment. The arrangement includes also the fixed connection of the oil delivery and return pipes near the coupling. 1 RWA35100 6.8.2 INSTALLING AND CONNECTING THE EQUIPMENT During the successive steps, take care to prevent any impurities from getting into the circuit.

2 - Remove the plugs of the two pipes and of the installed equipment. 237 The equipment must be installed following the procedure indicated in paragraph “3.13.5 CHANGING THE BACK- HOE BUCKET”. Connect the delivery and return pipes by proceeding as follows: 1 - After connecting the equipment, stop the machine and move the control pedal several times in both directions, in order to release any residual pressure. CAUTION CAUTION