INSTRUMENTS AND CONTROLS 76 • Shift the lever to the neutral position (N), turn the ignition key to position “I” and make sure that the display indicates (88). Start the engine and, after a quick self-test, the 2nd gear with semiautomatic logic (SA) will be displayed (15). 4 15 FWD N REV +- RWA12440 4 15 FWD N REV +- RWA12440 IMPORTANT • If the engine is not started within 20 seconds (program- mable) after turning the ignition key to position “I”, the electronic system inhibits the control and shows the fig- ure code dP on the display (15); turn the key to position “O” and repeat the starting procedure.
• If the lever is not in the neutral position, the red led N (4) comes on and the engine does not start. • If the anti-theft function has been connected before stop- ping the engine, after the self-test it is necessary to enter the anti-theft code. • This function is connected by pressing the push button (9) once (led 10 on) for at least 3 seconds before stopping the en- gine (this operation must be carried out by those who know the secret code). If the push button (9) is pressed more than once, the function is connected and disconnected in sequence, with the led (10) coming on and going out alternately.
10 +- 9 12 RWA12450 10 +- 9 12 RWA12450 IMPORTANT • After the engine start and the self-test, if the anti-theft function has been previously connected (led 10 on), the secret code figures must be entered one by one using the UP/DOWN buttons, while the push button 12 (DIM) must be used to confirm the entry. • After the entry of the correct secret code and the succes- sive acoustic confirmation, the anti-theft function is auto- matically excluded (led 10 off); to connect this function again, press the push button (9) before stopping the en- gine. • The anti-theft code is made up of 4 digits and is connected with the P/N stamped on the casing.
The digits are selected by means of the UP/DOWN buttons (0-9) and each digit is con- firmed with the button 12 (DIM). After the 4th digit has been confirmed, the electronic system acquires the code with 3 short beeps (0.3 secs) and the 2nd gear with semiautomatic logic SA is displayed. IMPORTANT • If an INCORRECT digit is confirmed, (88) appears on the display and a long beep (1 sec) is emitted; repeat the op- eration entering the right code. • After five consecutive INCORRECT confirmations, stop the engine and start it again.