INSTRUMENTS AND CONTROLS If the gears are shifted at unsuitable speed, the flashing led (13) comes on and this is signalled by a long beep (1 sec). The electronic control system does not carry out the shifting, but stores the selection. When the optimal rpm has been reached, the flashing led goes out and the selected gear is engaged. The electronic control system stores only one selection at a time. 13 15 + - The upshifting is carried out every 1.5 seconds without check- ing if the speed is optimal. If the UP/DOWN push buttons are pressed for more than 5 seconds, this is considered as a double selection.
Pressure on the UP/DOWN push buttons for more than 0.25 seconds is considered a selection. RWA17320 The engaged gear is always shown on the display (15).. The 4 th reverse gear is always disconnected. AUTOMATIC LOGIC PUSH BUTTON (AU) This function is connected by pressing the push button 11 (AUT) once, only with the machine at rest in safety condition (red led N (4) on). The automatic function AU is indicated by the coming on of two red points on the display (15). If the push button is pressed more than once, the function is connected and disconnected in sequence, with the two red points coming on and going out alternately on the display (15).
4 15 + - 11 RWA12500 78 4 FWD • With the machine at rest and reversing gear lever in neutral position, after 3 seconds the system signals an emergency condition and the red warning light N (4) comes on. Press the UP/DOWN buttons again and start again within 3 seconds. N REV +- RWA12490 N REV +- RWA12490 IMPORTANT • After the engine start, during the self-test and the entry of the anti-theft code, if any, before the 2nd gear is displayed, if the reversing gear lever is accidentally set to the FWD or REV position, the logic automatically recalls the emergen- cy function that prevents the accidental engagement from occurring again.